Sennheiser NET 1 Spezifikationen PDF herunterladen (Seite 10)

Putting the NET 1 into operation

When putting the NET 1 into operation for the first time or when changing

system components, operate the NET 1 with a PC.

Setting up the NET 1

Strong extraneous light may interfere with the transfer of the transmission

frequencies via the infra-red interface. Therefore, position the NET 1 so that

any possible interference caused by extraneous light is avoided.

Rack-mounting the NET 1

Note:

All NET 1 are delivered with the rack-mounting kit pre-assembled.

When rack-mounting the NET 1, please consider that, during operation, the

ambient temperature within the rack may significantly rise above room

temperature. However, the ambient temperature within the rack must not

exceed the temperature limit specified in the specifications.

When rack-mounting the NET 1, take good care not to affect the ventilation

required for safe operation or provide additional ventilation.

When rack-mounting the NET 1, ensure that its housing is not mechanically

loaded and that it is adequately supported at the rear, e.g. for transport.

When connecting the NET 1 to the power supply, observe the information

indicated on the type plate. Avoid circuit overloading. If necessary, provide

overcurrent protection.

Ensure a reliable mains ground connection of the device by taking

appropriate measures.

When rack-mounting the NET 1, please note that intrinsically harmless

leakage currents of the individual devices may accumulate, thereby

exceeding the allowable limit value. As a remedy, ground the rack via an

additional ground connection.

왘 Slide the NET 1 into the rack.

왘 Secure the NET 1 to the rack.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Keine Kommentare

Sennheiser NET 1 Spezifikationen Seite 10